LuanVan.vnLuận Văn
Gửi thư

Identification, design and synthesis of oxygenated hydrocarbon-based carbon dioxide-soluble polymers for chemical and petroleum engineering applications

Luận án · Tiến sĩ · năm 2006 · đề tài tham khảo

Loại tài liệuLuận án
Bậc họcTiến sĩ
Tác giảLei Hong
Cơ sở đào tạoĐại học Quốc gia TP. Hồ Chí Minh
Năm2006
NguồnThư viện số Đại học Quốc gia TP. Hồ Chí Minh · trang gốc

Tóm tắt

Over the past two decades the use of sub/supercritical CO2 has received much attention as a green alternative to organic solvents for chemical processes because of its pressure-tunable physicochemical properties and economic advantages. However the advantages are diminished because of a relative narrow range of CO2-soluble materials. The goal of this work is to identify, design and synthesize oxygenated hydrocarbon-based CO2-soluble polymers that are able to serve as construction blocks for copolymers, dispersants, surfactants, and thickeners. Without concerning on the cost and the environmental persistence like fluorinated materials, the inexpensive and environmentally benign materials would significantly enhance the viability of sub/supercritical CO2-based technology. Based on both experimental heuristics and ab initio simulation of molecular modeling (performed by Dr. Johnson's group), we proposed specific new polymer structures: poly (3-acetoxy oxetane) (PAO), poly (vinyl methoxymethyl ether) (PVMME), poly (vinyl 1-methoxyethyl ether) (PVMEE), and cellulose triacetate (CTA) oligomers. Phase behavior studies were also performed with novel CO2-philic compounds containing vinyl acetate, propylene glycol, or multiple tert-butyl groups. PAO, PVMME and PVMME were soluble in CO2, but not as soluble as poly (vinyl acetate). Oligomers of cellulose triacetate with as many as four repeat units solubilized into dense CO2 less than 14 MPa in the concentration range of 1-5 wt%. Phase behaviors of more than twenty compounds in dense CO2 were studied in this project. A new type of phase behavior for solid CO2-philes that melt and dissolve in CO2 was detailed using a model binary mixture of (3-D-maltose octaacetate and CO2. Copolymers of tetrafluoroethylene (TFE) and vinyl acetate (VAc) exhibited lower miscibility pressures than either of the homopolymers, probably due to quadradentate binding configurations with CO2. Phase behavior investigation of poly (propylene glycol) (PPG) monobutyl ether in CO2 demonstrated ether-CO2 interactions should receive as much attention as carbonyl-CO2 interactions when designing CO2-philic functional groups. 1,3,5-tri-tert-butylbenzene and 2,4,6-tri-tert-butylphenol were both extraordinarily soluble in CO2, and are excellent candidates for CO2-soluble sand binders. In summary, although a new CO2 thickener was not identified, new non-fluorous CO2-soluble materials were identified, which were, in general, acetate-rich with flexible chains, weak self-interactions, and multidentate interaction between CO2 and solute functional groups.
Bản toàn văn lưu tại thư viện Đại học Quốc gia TP. Hồ Chí Minh

Thông tin và tóm tắt ở trên lấy từ kho số mở của thư viện trường. Bản toàn văn do thư viện trường quản lý — có nơi cho đọc trực tuyến, có nơi cần tài khoản bạn đọc của trường.

Mở tại thư viện trường ↗
Dùng tài liệu tham khảo cho đúng
  • Đọc để hiểu cách người trước đặt câu hỏi, chọn phương pháp, trình bày số liệu — rồi tự làm với dữ liệu và bối cảnh của bạn.
  • Ý, số liệu, bảng biểu lấy từ tài liệu này phải trích dẫn (tác giả, năm, tên đề tài, cơ sở đào tạo).
  • Đề tài trùng tên vẫn làm được nếu khác đơn vị khảo sát, thời gian hoặc cách tiếp cận — nêu rõ điểm khác trong phần mở đầu.

Đề tài cùng ngành

Tác giả muốn gỡ, sửa thông tin hoặc bổ sung bản toàn văn: gửi yêu cầu qua trang Liên hệ, kèm đường dẫn trang này.