LuanVan.vnLuận Văn
Gửi thư

Experimental investigations on small-strain stiffness properties of partially saturated soils via resonant column and bender element testing

Luận án · Tiến sĩ · năm 2006 · đề tài tham khảo

Loại tài liệuLuận án
Bậc họcTiến sĩ
Tác giảPhayak Takkabutr
Cơ sở đào tạoĐại học Quốc gia TP. Hồ Chí Minh
Năm2006
NguồnThư viện số Đại học Quốc gia TP. Hồ Chí Minh · trang gốc

Tóm tắt

A comprehensive series of resonant column (ASTM D 2325-68), bender element (ASTM C 778), pressure plate (ASTM D 4015-92), and filter paper (ASTM D 5298) tests were conducted on compacted specimens of poorly graded sand (SP) and high plasticity clay (CH) in order to assess the influence of key environmental factors, namely compaction-induced matric suction and Ko stress state, on small-strain stiffness properties of partially saturated soils. Compaction-induced matric suction in all test specimens was estimated via soil-water characteristic curves (SWCC) for each type of soil. The research work was accomplished in six broad stages. During Stage I, a modified pressure plate extractor device was developed for assessing SWCC under anisotropic stress sates. Results from a series of SWCC tests on SP and CH specimens were used to assess the Fredlund and Xing’s SWCC model parameters for each type of soil. During Stage II, resonant column (RC) tests were conducted on SP and CH specimens, at different compaction-induced suctions and isotropic confinements, in order to devise correlations between small-strain stiffness properties, i.e. shear modulus (Gmax) and material damping (Dmin), and matric suction (V). During Stage III, bender element (BE) tests were conducted on SP and CH specimens for the same experimental variables as in Stage II. Results were used to investigate the influence of suction on bender element performance as compared to resonant column testing. During Stage IV, bender element (BE) tests were conducted on SP and CH specimens at different compaction-induced suctions and Ko stress states. Results were used to devise a correction factor for RC results, on the basis of initial compaction-induced suction, for any given Ko stress condition. During Stage V, a series of RC and BE tests were conducted on SP and CH specimens using a resonant column device with self-contained bender elements. Results were used to further substantiate the experimental findings and correlations devised in Stages II, III and IV. Finally, during Stage VI, bender element tests were conducted on SP and CH specimens sheared at different vertical strain levels in order to assess the influence of vertical strain level on suction loss and menisci regeneration patterns.
Bản toàn văn lưu tại thư viện Đại học Quốc gia TP. Hồ Chí Minh

Thông tin và tóm tắt ở trên lấy từ kho số mở của thư viện trường. Bản toàn văn do thư viện trường quản lý — có nơi cho đọc trực tuyến, có nơi cần tài khoản bạn đọc của trường.

Mở tại thư viện trường ↗
Dùng tài liệu tham khảo cho đúng
  • Đọc để hiểu cách người trước đặt câu hỏi, chọn phương pháp, trình bày số liệu — rồi tự làm với dữ liệu và bối cảnh của bạn.
  • Ý, số liệu, bảng biểu lấy từ tài liệu này phải trích dẫn (tác giả, năm, tên đề tài, cơ sở đào tạo).
  • Đề tài trùng tên vẫn làm được nếu khác đơn vị khảo sát, thời gian hoặc cách tiếp cận — nêu rõ điểm khác trong phần mở đầu.

Đề tài cùng ngành

Tác giả muốn gỡ, sửa thông tin hoặc bổ sung bản toàn văn: gửi yêu cầu qua trang Liên hệ, kèm đường dẫn trang này.